I have now gone and tried to manually change the alignment of the headlights (The yellow caps) using an allen key, but once again nothing is happening and no adjustment is shown. I've trawled around but i can't see anything which indicates how to rectify this issue, what could possibly be done or would it may need to be a garage job? headlights not working. my 2011 1.6 diesel focus has no dipped beam. the main beam, side lights, indicators all work. I have checked the fuses on the car, all seem to be fine. I spoke with ford and they want ridiculous money for the switch in the car, which works as the sidelights work when you turn them on. also the height adjustment also The front driver's side fender and mirror were torn completely off of the car. The front driver's side tire was damaged, and something was bent, so that the tire could no longer be set in a straight position. The hood was bent, and the driver's side headlight was hanging from the car. The interior portion of the driver's side foot well caved 1,986 Answers. The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support. You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). Step One: Park your vehicle facing a garage door or wall so that you can use it to check the direction of the headlight beams. Also, it is important that your vehicle is parked on a level surface. This is because if the ground is uneven, you may end up adjusting your lights too high or too low, you won’t be able to tell if they are in the In a situation whereby the new headlight does not glow, there may be corrosion or looseness of the socket. It is also possible that a wiring problem has occurred in the circuit of the headlight. If the problem is socket corrosion, you can get an aerosol electronics cleaner which should be used to spray the socket. The Focus headlights are not designed symetrically. Meaning, that the reflectors may already be designed to aim some of the light pattern slightly to the right (passenger side up and to the right), therefor, follow this guide using your headlights 'hotspots'. Drive your car right up to a wall (with car on a level surface). Showing how to operate the headlights on this particular model of a Ford ESCAPE. This particular model is a 2018 Ford escape Basic model. This video is for e On 1/1/2023 at 7:13 AM, gds1972 said: You could try swapping the module from one headlamp to the other and see if the problem moves to work out of its the light or module. Just don't forget to swap them back. If it is the headlamp is would be asking for some goodwill from Ford. Expand. Failure Date: 06/01/2015. The contact owns a 2009 Ford Fusion. The contact stated there was condensation in the headlamp. The vehicle was taken to westfield Ford (6200 south la grange road, countryside, IL 60525, (708) 354-8600) where the contact was informed that the headlamp housing needed to be replaced. HpDmXUU.